How to make a new file system how to#
How to make a new file system software#

Note: here we have taken sda because fdisk -l show us our hard disk is sda type not hda or hdb.

How to make a new file system software#

There is nothing wrong with that, but this is larger than 1024,Īnd could in certain setups cause problems with:ġ) software that runs at boot time (e.g., old versions of LILO)Ģ) booting and partitioning software from other OSs

The number of cylinders for this disk is set to 3263. We do partition or you can say disks are partitioned to make a separate File System according our need.

How to make a new file system how to#

Step2: See how to create a new Partiton using fdisk tool.(Partitioning Device) Vendor: HUAWEI Model: MMC Storage Rev: 2.31 Vendor: HUAWEI Model: Mass Storage Rev: 2.31 -> My HUWAEI USb Modem

Type: Direct-Access ANSI SCSI revision: 02 Vendor: Kingston Model: DataTraveler G2 Rev: 1.00 -> My usb Device Type: Direct-Access ANSI SCSI revision: 05 Vendor: ATA Model: ST3160215AS Rev: 4.AA -> My hard Disk We use here some commands to know the detail information of hard disk we are using and we are going to ~]# lspci|grep -i ideĠ0:1f.1 IDE interface: Intel Corporation 82801G (ICH7 Family) IDE Controller (rev 01)Ġ0:1f.2 IDE interface: Intel Corporation 82801GB/GR/GH (ICH7 Family) SATA IDE Controller (rev ~]# cat /proc/scsi/scsi So now we have to create a new partion that will start from /dev/sda6īefore Partition we need to know about our hard disk in use. We have seen that already partition up to /dev/sda5 has been created. Using Fdisk command one can identify his device that whether it is your internal Hard disk or external hard disk.ĭisk /dev/sda: 26.8 GB, 26843545600 bytesĢ55 heads, 63 sectors/track, 3263 cylinders The tools used in this tutorial are very as mentioned below.įirst check the partition table using fdisk command. This article will also take you through the steps to delete your required partition, view your hard drive geometry,display existing partition table,display the UUID of a partition and many more about partition creation ,view,help, partitioning command line help and troubleshooting. In this post we will be going through simple steps to create a new partition in linux, format it and mount it at your required mount point. Creating and deleting new partitions in linux a very normal practice.